The diagram below shows samples of each type of endpoint.Įach endpoint has an associated Scale that determines the size of the endpoint in relation to the Line Width. Start and End: Controls the appearance of the endpoints for each side of the line. Style: Determines the pattern of the line segment. Line Width: Sets the line thickness in points. Opacity: Sets opacity level of the line and endpoints, from 0 (invisible) to 100 (opaque). Highlight: Makes the fill color and line transparent so underlying content shows through. See Editing Markups for more information.įill Color: Controls the fill color of the endpoints. To rotate the caption 180°, right-click the markup and select Flip Text. ![]() Note that only the cumulative length caption can be rotated while the length captions of the segments cannot be rotated, they can be adjusted to align on the segment or horizontally in the Appearance Properties. By default, the markup is rotated in increments of 15° to rotate in increments of 1°, hold down SHIFT while dragging.To return a rotated caption to its original position, right-click it and select Reset Caption Position. To rotate the caption, click and drag the orange handle directly over it. Note that, if multiple captions in a Polylength measurement are moved, right-clicking one and selecting Reset Caption Position will reset the positions of them all. To move multiple captions at the same time, SHIFT-click them, then click and drag one of the selected captions while holding down SHIFT. To move only the caption, click and drag it while holding down SHIFT. To return the caption to its default position, right-click it and select Reset Caption Position. To move the entire markup together, click and drag a part of it other than the control handles. By default, the markup is rotated in increments of 15° to rotate in increments of 1°, hold down SHIFT while dragging. To rotate the markup, click and drag the orange handle outside the markup (when the markup is first placed, it will be at the top). Each handle controls a different aspect of the markup's size and orientation. Select a markup to reveal its control handles. To break a the measurement into its segmented parts, select Split All. ![]() To do so, right-click the desired segment and select Split. Segments of a the measurement can be split from the original markup.Rise/Drop is mutually exclusive with Depth. To set a rise/drop for the markup, enter a value the unit of measure is automatically the same one used for the markup length. The value entered here represents the total amount of rise and/or drop and will be added to the length total. Rise/Drop allows for accurate measurements of materials that run up or down from one floor to the next, such as piping or conduit.Depth is mutually exclusive with Rise/Drop. To set a depth for the markup, enter a value and select a unit of measure. Depth allows for additional calculations, such as wall area or material volume, on the Markups list. ![]() In the Measurements section on the Measurements tab, certain fields are available to add detail and dimension to the markup, including: Hold down SHIFT to draw lines that are at horizontal, vertical, or 45° angles.Double-click when placing the last point.To complete the shape without "closing" it, do one of the following:.For a closed-shape measurement, see Area Measurement. Note: Even though their start and end points can touch, Polylength measurements are always considered open shapes and will behave as such. To "close" the shape, click on the starting point of the first line segment. Note that, if the Show Segment Values is enabled on the Properties tab, a cumulative length measurement is shown (in addition to the length measurement of the segment itself) when there are multiple segments in the markup.Repeat this process to create as many line segments as desired. Click the end point of the next line segment.Click the end points of the first line segment.Alternatively, click Polylength on the Measurements tab.The Polylength measurement mode is engaged. Go to Measure > Polylength or press SHIFT+ALT+Q.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |